ARDUINO ETHERNET SHIELD W5100

Description:

The Arduino Ethernet Shield allows an Arduino board to connect to the internet. It is based on the Wiznet W5100 ethernet chip providing a network (IP) stack capable of both TCP and UDP. The Arduino Ethernet Shield supports up to four simultaneous socket connections. Use the Ethernet library to write sketches which connect to the internet using the shield.

The ethernet shield connects to an Arduino board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top..

The latest revision of the shield adds a micro-SD card slotwhich can be used to store files for serving over the network. It is compatible with the Arduino UNO and Mega (using the Ethernet library coming in Arduino 0019). An SD card library is not yet included in the standard Arduino distribution.

Arduino communicates with both the W5100 and SD card using the SPI bus (through the ICSP header). This is on digital pins 1112and 13 on the Duemilanove and pins 5051and 52 on the Mega. On both boardspin 10 is used to select the W5100 and pin 4 for the SD card. These pins cannot be used for general i/o. On the Megathe hardware SS pin53is not used to select either the W5100 or the SD cardbut it must be kept as an output or the SPI interface won't work.

Specification :

• Microcontroller: Wiznet W5100
• Operating voltage: 5V
• Input voltage (recommended): 7-12V
• Input voltage (limits): 6-20V
• Ethernet controller: W5100 with internal 16K buffer
• Connection speed: 10/100Mbps
• Connection with Arduino on SPI port
• Connection with SD card: Yes (onboard SD card slot)
• Power over Ethernet ready (PoE module sold separately)
• Supports up to 4 simultaneous socket connections
• Compatible with DHCP and DNS protocols
• Compatible with HTTP and FTP protocols
• Compatible with Arduino Uno, Mega, and Duemilanove